Baby Bath Warm Bath Rack Newborn Sitting and Lying Holder Artifact Baby Bathtub Universal Bath Bed Holder Anti-Slip Mat Bath Net -1pcs

Product Overview

A bath support rack that sits inside a bathtub and holds a newborn in place, either reclined or partly upright. The surface is an anti-slip mesh, so the baby is cradled rather than sliding on a hard base, and it fits most standard baby baths.

The point of a support is that washing a newborn otherwise takes both hands and you only have one — the other is holding the baby up. A rack takes that job so you can actually wash them.

Key Benefits

• Holds a newborn securely in a sitting or lying position
• Frees both hands for washing
• Anti-slip mesh surface, comfortable against skin
• Fits most standard baby bathtubs
• Water drains straight through the mesh

Key Features

• Baby bath support rack / bath bed
• Sitting and lying positions
• Anti-slip mesh net
• Universal fit for baby bathtubs
• 1 piece

Important — A Support Is Not a Safety Device

This needs saying plainly, because bath supports and seats are widely misunderstood. A rack holds a baby in position; it does not stop them slipping down, tipping sideways, or ending up face-down. Babies drown in bath seats, and the pattern is nearly always the same: an adult stepped away for a moment believing the seat was holding the baby safely.

• Never leave the baby unattended, not for a second.
• Keep a hand on the baby throughout.
• Take the baby with you if you have to leave the room.
• Keep the water shallow — a support does not change how much water a baby can drown in.

Bath Safety

• Never leave a baby alone in the bath, not even for a second. An infant can drown in a few centimetres of water and it happens silently. If you must answer the door or the phone, take the baby with you.
• Run cold water first, then add hot, and test the temperature with your elbow or wrist — around 37°C. Hands are poor thermometers.
• Keep one hand supporting the baby at all times.
• Wet bathroom floors and soapy babies are slippery. Have the towel within reach before you start.
• Bath seats and rings are not safety devices. They tip.

How to Use

1. Place the rack in the empty tub and check it is stable and properly seated.
2. Run the water to about 10cm and test at 37°C with your elbow.
3. Lower the baby on, supporting the head, and keep one hand on them.
4. Wash with your free hand.
5. Rinse the rack after use and let it dry fully — mesh holds water and grows mould if it stays damp.

Frequently Asked Questions

What age is it for?

Newborn until the baby can sit up unaided and starts pushing against it — usually around six months.

Will it fit my bathtub?

It is designed as a universal fit for standard baby baths. Check it sits stable in yours before the first use.

How do I stop it going mouldy?

Rinse and hang it to dry after every bath rather than leaving it in the tub.